General Electric IS200EPCTG1A Exciter PT/CT Terminal Board

GE IS200EPCTG1A Exciter PT/CT Terminal Board

The GE IS200EPCTG1A, also cataloged as the IS200EPCTG1A exciter PT/CT terminal board, serves as the primary isolation‑transformer interface used to execute generator PT voltage and CT current signal routing across EX2100 excitation platforms. The board provides transformer‑isolated measurement paths, fused PT inputs, CT‑safe terminal blocks, and one selectable analog input for voltage or 4–20 mA current.

Hardware Specifications

Backplane Bus Communication Velocity Licenses

As an EX2100 excitation‑system measurement board, EPCT aligns with deterministic controller timing and transformer‑isolated signal propagation:

• Profinet deterministic networks — stable cycle timing when upstream controllers enforce scheduled exchanges.
• EtherNet/IP deterministic behavior — predictable negotiation windows for CIP‑based traffic.
• I/O density scaling — consistent propagation delay across expanded excitation‑control node counts.
• Firmware flash compatibility — EPCT remains passive; transformer outputs feed EMIO boards without firmware dependency.

Frequently Asked Questions (FAQ)

Q: Can EPCT boards be used in redundant configurations? A: Yes. Up to three EPCT boards may be installed for highest reliability, with voltage and current signals fanned to M1, M2, and C controllers.

Q: How is the analog input type selected? A: Jumper JP1 selects voltage or 4–20 mA current mode.

Q: Why are TB2 and TB3 non‑removable? A: They prevent accidental CT open‑circuit conditions, which can damage CTs or produce unsafe voltages.

Field Installation Guidelines

• Use #12 AWG wiring for PT and CT inputs; maintain fused PT connections and ensure CT circuits remain closed during installation.
• Maintain transformer‑secondary wiring separation to reduce noise coupling into EMIO measurement paths.
• Verify JP1 jumper position before energizing to ensure correct analog‑input mode.
• Keep TB1 removable for maintenance; do not remove TB2 or TB3 under any circumstance.
• Ensure proper seating of connectors J305, J308, and J315 for stable controller fanout.
• Use test points TP1–TP8 for transformer‑secondary verification during commissioning.