- Home
- GE IC693bem330 Communication Scanner Modules
Sale
GE IC693bem330 Communication Scanner Modules
No reviews
In stock!
- Part Number: IC693bem330
- Brand: General Electric
- Type: Communication Scanner Modules
- Barcode: USA
Share
Product Description
Configured for remote distributed I/O scanning over Factory Instrumentation Protocol (FIP) networks, the GE IC693BEM330 (IC693BEM330 FIP I/O Scanner Module) provides direct physical/electrical execution.
Suffix Breakdown & Model Matrix
| Code Suffix | Module Interface & Function Breakdown |
|---|---|
| IC693 | Series 90-30 programmable logic controller hardware family identifier |
| BEM330 | Factory Instrumentation Protocol (FIP) remote I/O scanner module variant |
| 1 MHz FIP | WorldFIP protocol communication interface running at 1 MHz data rate |
| Dual 9-pin D-shell | Two female 9-pin D-sub connectors for redundant FIP network channel connections |
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC693BEM330 |
| Brand | GE |
| Origin | USA |
| Weight | 0.37 kg (0.81 lbs) |
| Dimensions | Single-slot Series 90-30 Form Factor |
| Operating Temp | 0 deg C to 60 deg C |
| Power Consumption | 609 mA at 5 VDC backplane supply |
| Protocol Support | FIP and WorldFIP (1 MHz transmission rate) |
| Mounting Location | Slot 1 of CPU / Scanner Baseplate |
| Maximum Modules | Up to 19 I/O modules across 2 interconnected baseplates |
| Communication Ports | Two (2) 9-pin D-shell female connectors, one SYNCHRO port (#39-01-4031) |
| Front Panel Diagnostics | CD1, TEN1, CD2, TEN2 LED status indicators |
Deterministic Backplane Communication & I/O Density Scaling
The scanner module resides exclusively in Slot 1 of the expansion baseplate to map distributed field data directly to the host CPU. By processing FIP protocol variables at 1 MHz, the unit maintains predictable cycle timing across high I/O density scaling configurations up to 19 expansion cards. Backplane bus communication velocity is optimized to ensure deterministic transfer of discrete and analog I/O points, while firmware flash compatibility maintains synchronous data exchange with Series 90-30, Series 90-70, and remote Bus Interface Units (BIU).
Frequently Asked Questions
Q: What mounting slot restrictions apply to the IC693BEM330 scanner card?
A: The scanner module must be installed strictly in Slot 1 of the CPU or remote scanner baseplate to access the primary backplane control lines.
Q: What is the purpose of the front-panel SYNCHRO connector?
A: The SYNCHRO port terminates the FIP network synchronization cable using a Molex catalog #39-01-4031 connector to preserve timing alignment across network nodes.
Q: What do the front-panel LED indicators signal during operation?
A: CD1 and CD2 indicate Carrier Detection state on FIP Channels 1 and 2, while TEN1 and TEN2 illuminate during active data transmission on their respective channels.
Field Installation Guidelines
- Ensure the Series 90-30 rack power supply is fully de-energized prior to inserting the scanner module into Slot 1 of the baseplate.
- Align the module circuit board with the Slot 1 guide slots and tilt the top hook into the backplane notch, pressing downward until the bottom connector seats firmly.
- Tighten the rear connector seating pin and ensure the Molex SYNCHRO plug is secured if network time synchronization is required.
- Route dual 9-pin D-sub FIP communication cables in dedicated wireways separate from high-voltage AC conductors, grounding cable shields at a single point to prevent high-frequency noise interference.
Have a Question?
